Christie CP2000-XB Setup Manual page 51

3. DEFINE SYNC INPUT LOCATION:
For dual inputs,
• Set the L/R Input Reference option to Active Port:
A/R = L/R (or vice versa).
• Set the Input GPI to None.
These two settings tell the rest of your 3D system that
incoming 3D stereo sync information is included with
the two L/R image data inputs rather than routed sepa-
rately to the GPIO port.
For future single-input 3D sources where the server sup-
plies a separate 3D stereo sync to the projector's GPIO
port instead, set Input GPI according to which input # is used (i.e., according to your GPIO cable wiring).
4. DEFINE L/R DOMINANCE:
Choose the leading frame, left or right. Correct order depends on the cameras used during filming, and is
needed to ensure smooth motions. An incorrect setting creates motion artifacts.
5. DEFINE SYNC DISPLAY LOCATION:
• Set L/R Display Reference to Not Used.
• Set Display GPI to None.
6. DEFINE SYNC OUTPUT:
• Set L/R Output Polarity to Inverted. NOTE: If the display appears inverted, i.e. background appears
close and foreground appears at a distance, you will need to make sure that the cable connecting server
output A is connected to projection input A and the cable connecting server output B is connected to pro-
jection input B.
• Set Output GPO according to which of the projector's GPIO outputs is currently wired to your emitter
or polarizer.
7. CONNECT GPIO (OUTPUT):
From the projector's GPIO port, connect your 3D Stereo Sync cable to your 3D controlling device such as
an emitter or polarizer. NOTE: RealD 3D sync cable recommended.
8. ADJUST DISPLAY, SCREEN, ETC.:
As desired, adjust the image color, etc.
CP2000-XB Setup Guide
020-100250-02 Rev. 1 (06-2009)
Section 3: Basic Operation
Step 3
Step 5
Step 6
Figure 3-4 Setup for 3D
3-11