Cooling; Extractor Fan And Duct - Christie CP2000-XB Setup Manual

STEP 1: Check Lamp Cradle (Anode End) Location for Your Lamp
The CP2000-XB accommodates different lamps. Refer to the CP2000-XB User Manual (020-100163-xx) for
a complete list of supported lamps.
• For 4.5 or 6.0 kW lamps, the lamp cradle must be as far forward as
possible (factory default).
• For 2.0 or 3.0 kW lamps, move the cradle to the rear position, i.e.,
approximately 1" closer to the reflector. See Figure 2-22.
STEP 2: Install Lamp
Refer to Section 4.3 Filter Replacement
warnings, and wear protective clothing and shielding.
Don't forget to properly mark the Lamp Installed label on the lamp
door to indicate current lamp size. Also set the Lamp Type in the TPC
Lamp menu (service/installer login required) before turning on the
projector.

2.4.3 Cooling

Extractor Fan and Duct

For any CP2000-XB with any lamp, install the Christie extractor fan and duct to pull warm exhaust air from
the projector at a minimum rate of 450 CFM (for 2 or 3 kW lamps) or 600 CFM (for 4.5 kW or higher lamps).
Use either the 6-in. or the 6-ft. long duct in one of the configurations shown in Figure 2-23.
Direct the exhaust, as necessary, to keep ambient air temperature within operating spec. If the projector is used
for extended periods, particularly in a confined space, routing to the outside of the building may be required. In
all cases, maintain either 450 or 600 CFM at the projector's top exit port.
CP2000-XB Setup Guide
020-100250-02 Rev. 1 (06-2009)
, steps 7-11. Observe all
Figure 2-23 Extractor Fan Configurations
(MANDATORY SAFETY CABLING NOT SHOWN)
Section 2: Installation & Setup
Figure 2-22 Move Cradle Back for
2.0 or 3.0 kW Lamps
2-15