Nokia M10 User Manual page 65

DRAFT
Nokia M10 User's Manual
3. Configure Routing Information Protocol (RIP) settings.
Enable/disable dynamic routing for the active IP interface on the
ATM channel by selecting the corresponding radio buttons. If
RIP-send is selected the M10 sends RIP messages (version 1, 2 or
both) to the network. If RIP-receive is selected the M10 listens to
RIP messages from the network. RIP-send with V1-compat option
enables the sending of RIPv2 packets using multicast. RIP-receive
with V1-compat option accepts both RIPv1 and RIPv2 packets.
4. Add static routes to the routing table of the interface.
Enter destination address, net mask and gateway and press Add.
5. Save the configuration.
You must save the new configuration. Save command takes you to
the M10 home page.
6. Restart your M10.
You must restart your M10 by clicking Restart M10 for your
changes to take effect.
5-16
Copyright Nokia Telecommunications Oy NTC C33539002SE_A0