Nokia M10 User Manual page 105

DRAFT
Nokia M10 User's Manual
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
Use the following commands to configure settings for routing IP over
PPP link.
Command
Description
Syntax
Arguments
Example
Note
5-56
Set default gateway IP address
Specifies the IP address of the default IP gateway. Only
applies when the default gateway interface is ip-ad-
.
dress
set ip gateway default [ip_address]
ip_address argument is the IP address of the default
gateway.
m10> set ip gateway default 191.233.22.1
Enable IP packet forwarding and route distribution
between ATM VCC interfaces
Enable/disable IP packet forwarding and route distribu-
tion between ATM VCC interfaces. If only one VCC is
used this option can be ignored.
set ip interwan-routing [on|off]
The argument enables/disables interwan routing.
m10> set ip interwan-routing on
Enable/disable routing IP over PPP link
Enables/disables IP routing through the specified logi-
cal ATM channel using ppp-vcmux encapsulation.
set ip ip-ppp {vccx} option [on|off]
The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument vccx
out. The on/off argument enables/disables routing.
m10> set ip ip-ppp vcc1 option off
You must enable IP routing before you can enter other
IP routing settings for the serial port. If you turn off IP
routing and save the new configuration, the Nokia
M10 clears IP routing settings.
Copyright Nokia Telecommunications Oy NTC C33539002SE_A0