Nokia M10 User Manual page 110

Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
NTC C33539002SE_A0
Set broadcast address to channels using IP over
ATM or bridged encapsulations
Assigns a broadcast IP address to the specified logical
ATM channel using ip-llc, ip-vcmux, ether-llc, or ether-
vcmux encapsulation.
set ip dsl {vccx} broadcast [broadcast_address]
The first argument identifies the ATM channel. The sec-
ond argument is the broadcast address to be assigned
to that channel. If there is only one ATM channel using
one of these encapsulations you can leave the argu-
ment vccx out. If you enter 0.0.0.0 as the IP broadcast
address Nokia M10 will retrieve the IP address through
the remote peer using Dynamic Host Configuration Pro-
tocol.
m10> set ip dsl vcc2 broadcast 0.0.0.0
Set network mask to channels using IP over ATM or
bridged encapsulations
Assigns an IP network mask to the specified logical
ATM channel using ip-llc, ip-vcmux, ether-llc, or ether-
vcmux encapsulation.
set ip dsl {vccx} netmask [netmask]
The first argument identifies the ATM channel (vccx, x =
1 ... 8). The second argument is the network mask to
be assigned to that channel. If there is only one ATM
channel using one of these encapsulations you can
leave the argument vccx out. If you enter 0.0.0.0 as
the network mask Nokia M10 will retrieve the IP ad-
dress through the remote peer using Dynamic Host
Configuration Protocol.
m10> set ip dsl vcc2 netmask 0.0.0.0
Copyright Nokia Telecommunications Oy
DRAFT
Management
5-61