Software Download - Nokia M10 User Manual

5.4

Software download

New software can be downloaded to the Nokia M10 via the 10Base-T
Ethernet interface. Nokia M10 uses Trivial File Transfer Protocol
(TFTP) to download the software from a TFTP server located in the
Ethernet LAN. The downloading is activated from the console port
using the CLI. Use the following CLI command to download new
software to M10:
install [server_address] [filename] {confirm}
Command
Description
Syntax
Arguments
Example
NTC C33539002SE_A0
Download software update
Downloads a new version of the Nokia M10 operating
software from a TFTP (Trivial File Transfer Protocol)
server, validates the software image, and programs the
image into the Nokia M10 memory. After you install new
operating software, you must restart the Nokia M10.
install [server_address] [filename] {confirm}
The TFTP server must be accessible on your Ethernet
network or through one of the active ATM virtual chan-
nels and a route to the server must exist. The server
address argument identifies the IP address of the
TFTP server on which your Nokia M10 operating soft-
ware is stored. The filename argument identifies the
path and name of the operating software file on the
TFTP server. If you include the optional confirm key-
word, you will not be prompted to identify a TFTP
server or file name. Your Nokia M10 begins the soft-
ware installation using its default boot settings.
M10> install 192.168.1.1 m10c_500.d39
*** WARNING *** YOU ARE ABOUT TO ERASE
AND REPROGRAM THE NOKIA M10'S PERMANENT
SOFTWARE STORAGE WITH A NEW SOFTWARE VER-
SION OBTAINED VIA THE TFTP PROTOCOL.
About to install new Flash EPROM software
image:
server: 192.168.1.1
file: "m10c_500.d39"
Do you wish to proceed? (type 'yes' to
confirm): yes
Installing
M10>
Copyright Nokia Telecommunications Oy
DRAFT
Management
5-91