Nokia M10 User Manual page 107

DRAFT
Nokia M10 User's Manual
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
5-58
Enable/disable address mapping on ATM link using
PPP-vcmux encapsulation
Specifies whether you want Nokia M10 to use NAPT on
the specified ATM link using ppp-vcmux encapsulation
when communicating with remote routers. Address
mapping lets you conceal details of your network from
remote routers, which is useful when connecting to an
Internet Service Provider. By default, the address map-
ping is turned on.
set ip ip-ppp {vccx} addr-mapping [on|off]
The first argument identifies the ATM channel (vccx, x =
1 ... 8). The second argument enables/disables ad-
dress mapping on that channel.
m10> set ip ip-ppp vcc2 addr-mapping on
Enable/disable RIP send function on PPP link
Specifies whether the Nokia M10 should use Routing
information protocol (RIP) broadcasts to advertise its
routing tables to router on the other side of the speci-
fied ATM link using ppp-vcmux encapsulation. RIP can-
not be activated if address mapping is ON.
set ip ip-ppp {vccx} rip-send [off | v1 | v2 | v1-compat]
The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument vccx
out. Both RIP version 1 and RIP version 2 functiona-
lities can be simultaneously activated. v1-compat
argument enables the sending of RIPv2 packets using
IP multicast.
m10> set ip ip-ppp vcc2 rip-send off
Copyright Nokia Telecommunications Oy NTC C33539002SE_A0