Nokia M10 User Manual page 113

DRAFT
Nokia M10 User's Manual
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
5-64
Flush routes
Enabled flush routes function deletes the learned
routes from the routing table when the PPP connection
is disconnected. Address mapping must be off.
flush-routes [on|off]
The argument enables/disables flush routes function.
m10> flush-routes on
Enable/disable the management through channels
using IP over ATM or bridged encapsulations
Enables/disables the management of Nokia M10
through the specified ATM link using ip-llc, ip-vcmux,
ether-llc, or ether-vcmux encapsulation.
set ip dsl {vccx} admin-disable [on|off]
The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using one of
these encapsulations you can leave the argument
vccx out. The second argument disables/enables man-
agement through the PPP link.
m10> set ip dsl vcc2 admin-disable off
Enable/disable IP routing on ATM channel
Enables/disables IP routing on the specified ATM chan-
nel using PPP over ATM encapsulation in bridged
mode (BNCP option on).
set ip wan {vccx} option [on|off]
The first argument identifies the ATM channel (vccx, x =
1 ... 8). If there is only one ATM channel using ppp-
vcmux encapsulation you can leave the argument vccx
out. The second argument enables/disables the func-
tion.
m10> set ip wan vcc2 option off
Copyright Nokia Telecommunications Oy NTC C33539002SE_A0