Atm Settings - Nokia M10 User Manual

DRAFT
Nokia M10 User's Manual

ATM settings

You can enable ATM over ADSL operation and configure up to eight
ATM channels into use. You can select between five different ways to
encapsulate your payload in an ATM channel. You can also fine tune
the physical layer parameters of the ATM channel. See also DMT
(ADSL) settings on page 5-78.
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
Command
Description
Syntax
Arguments
Example
5-48
Enable/disable ATM
Enables/disables the use of ATM on the ADSL link. Dis-
abling ATM forces M10 to work in a frame mode on the
ADSL link.
set atm option [on | off]
The argument enables/disables ATM.
m10> set atm option on
Set ATM cell header of an empty cell
Defines the ATM cell header of an empty (idle) ATM cell
as an 8-bit variable. This command affects the low-level
functionality of the ATM physical layer link and usually
you do not have to change this setting.
set atm cell ehead [0xbbbbbbbb]
ADSL standard value is 0x00000001 or 0x00000000
depending on the DSLAM. Nokia B20 requires the
value 0x00000001.
m10> set atm cell ehead 0x00000001
Set payload content of an empty cell
Defines the payload content of an empty (idle) ATM cell
as an 8-bit variable. This command affects the low-level
functionality of the ATM physical layer link and usually
you do not have to change this setting.
set atm cell epayload [0xbbbbbbbb]
ADSL standard value is 0x6A6A6A6A.
m10> set atm cell epayload 0x6A6A6A6A
Copyright Nokia Telecommunications Oy NTC C33539002SE_A0