Sharp AR-FX12 Service Manual page 51

SW Bit Item
No. No.
40 5 Report output
(in confidential
reception)
<FAX only>
6-8 Not used
41 1,2 Send mode document
content print
(Report table)
<FAX only>
3,4 Report output
(transmission)
<FAX only>
5,6 Report output
(sequential broadcast,
sequential polling, relay
broadcast)
7,8 Report output
(reception)
<FAX only>
42 1-3 Not used
4 F.A.S.T function
5-7 Not used
8 V.34 mode function in
manual communication
43 1 V.34 mode function
(When call out and
polling)
Switch selection and function
Used to set whether the communication report table (reception) is outputted or
not in confidential reception.
1: Communication report
table is not printed.
Used to set whether part of a send document is printed on the communication
report (send) or not in FAX send error. However, use the other soft switch to set
whether the communication report is printed or not.
Bit No.
Not print
Always print
In case of an error
In case of an error
Used to set the communication report table output after transmission (except for
sequential broadcast, sequential polling, relay broadcast).
Bit No.
Print inhibited
All print
Only when transmission is failed
Only when transmission is failed
Used to set the communication report table output after transmission
(sequential broadcast, sequential polling, relay broadcast).
Print inhibited
All print
Only address to which transmission is failed
All print
Used to set the communication report table output in reception (except for
confidential reception).
Bit No.
Print inhibited
All print
Only in case of an error
Print inhibited
Used to set the management function performed in FAX communication
through the telephone line.
1: YES
Used to set Enable/Disable of V.34 mode function in manual communication.
When, however, SW43-1 is set to "1:disable," V.34 mode is disabled though this
switch is set to "0:enable."
1: V.34 mode function
disable
Used to set Enable/Disable of V.34 mode function in the machine when
sending.
1: V.34 mode function
disable
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-39
0: Communication report
table is printed.
1 2
0 0
0 1
1 0
1 1
3 4
0 0
0 1
1 0
1 1
Bit No. 5
0
0
1
1
7 8
0 0
0 1
1 0
1 1
0: NO
0: V.34 mode function
enable
0: V.34 mode function
enable
USA Initial value
0 Output
0
0
0
1 In case of
an error
0
1 Only when
transmission
0
is failed
0 All print
1
6
0
1
0
1
0 Print
inhibited
0
0
0
0
0 NO
0
0
0
0 Enable
0 Enable
Key
operator
Initial setup
Initial setup
Initial setup
Initial setup
Initial setup