Sharp AR-FX12 Service Manual page 47

SW Bit Item
No. No.
26 4-8 Not used
27 1-4 Echo suppressor tone
setup
5-8 Not used
28 1-3 Not used
4-6 CNG signal detection
time (in TEL/FAX auto
selection)
7,8 Not used
29 1-5 FAX paper exit tray
setting
6-8 Not used
30 1 Not used
2 Error reception in RTN
reception
3-4 Not used
5-8 ID (No.) setting
(1st digit: When dial
inputting or dialing)
Switch selection and function
Used to set YES/NO of echo suppressor tone in each high-speed modulation
system.
Bit No.
V.33 1
V.17 2
V.29 3
V.27 4
Used to set the time for detection of the CNG signal of the remote machine
before calling an external telephone from connection of the line when the FAX
automatic selection is enable. When this item is set to a longer value, the mute
time on the calling side becomes longer.
Setting range: "Setting value + 2 sec"
When, however, it is set to 0, the time is 0 sec.
Used to specify the default output tray in the combination of each output
system. The combinations of the output trays are as follows.
In the case of the main unit only or the main unit without the manual feed tray
and with the duplex tray, the output is always made from the center tray.
Main unit + Manual Duplex
Finisher + Duplex / Finisher
Mail bin stacker + Duplex /
Mail bin stacker
Main unit + Saddle finisher
+ Duplex
Mail bin stacker + Saddle
finisher
Used to set whether RTN signal reception is judged as an error or not. (Only in
G3 mode)
1: RTN reception is not
judged as an error.
Used to set the ID No. when the PBX function is enabled. This setting is valid
when "ID" is set in SW59-7-8.If the set value is outside the specified range, the
default (0) is used.
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-35
1 : NO 0 : YES
1 : NO 0 : YES
1 : NO 0 : YES
1 : NO 0 : YES
Bit No.
1 1:CENTER 0:LEFT TRAY
TRAY
2 1:FINISHER 0:LEFT TRAY
TOP TRAY
3 1:MAIL BIN 0:LEFT TRAY
TOP TRAY
4 1:CENTER 0:FINISHER
TRAY TRAY
5 1:MAIL BIN 0:FINISHER
TOP TRAY TRAY
0: RTN reception is
judged as an error.
USA Initial value Key
operator
0
0
0
0
0
0 YES
(No for V.29
0
only)
1
0
0
1
1
1
0
0
0
0 Receive
setup
0
0
0
0
0 Receive
setup
0
0
0
0
0
0
0
0
0 Judges as
an error
0
0
0 0 Initial set up
0
0
0