Sharp AR-FX12 Service Manual page 49

SW Bit Item
No. No.
35 5 Received document
output setup
6 Not used
7 Automatic reduction/
dispose setup
8 Reduction/dispose
setup when printing A3,
11X 17
36 1-8 Setup of magnification
ratio in automatic
reduction
37 1,2 Reception size
specification
(Indicates reception
capacity.)
3 11 x 17 paper reception
width setup
4 Date/sender print
language selection
5 Default date/sender
print
6 Date/sender information
print position setup
Switch selection and function
Used to set whether all received data are collectively printed after completion of
all FAX reception or each page is printed after completion of reception of each
page.
1: Each page is printed
after reception of each
page.
Used to set whether automatic reduction is made so that the received data can
be printed on a page if reduced, when a document the size of which exceeds
the printable limit but is within the magnification ratio setup range of automatic
reduction is received.
1: Automatic reduction is not made and
data exceeding the printable limit are
disposed.
Used to set whether the main scan width data are reduced or data on both
edges are disposed without reduction when A3 width document is received and
printed on 11x 17 inch paper. When set to "Reduction," the data are reduced by
94%.
1: Dispose
Used to set the percentage by which the received document is longer than the
printable length when automatic reduction print is enabled. The setup range is
85 - 100% by binary input of N into "N x 1% + 85%."When set to outside the
range, similar to the default value of 90%.
Used to set the reception allowable document width of the machine which is
notified to the other party machine when receiving
Bit No.
By installed cassette
A4 width
B4(A4•B4) width
A3(A3•B4•A4) width
When using the installed cassette, the max. cassette size as follows :
A5/5.5 x 8.5R size
B5 size
A4/8.5 x 11 size
8.5 x 13/8.5 x 14
B4 size
11 x 17
A3 size
A3 width is used when no tray is set for Fax reception and printing and when the
cassette is open in case of installed cassettes.
Used to set the reception allowable document width when 11 x 17 paper is
selected as FAX print paper.
1: B4(B4•A4) width
Used to set the date and FAX No. print (depending on the destination) at the top
of the document when transmitting. Date, FAX No. and fonts are switched.
1: For North America
Used to set whether the date and sender information are added at the top of the
transmitted document as default.
1:Not added
Used to set the print position of the date/sender information at the top of the
transmitted document.
1: Top of document
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-37
0: Collectively printed
after completion of all
FAX reception
0: Printed by
automatic
reduction
0: Reduction
1 2
0 0
0 1
1 0
1 1
A4 width
B4 width
A3 width
A3 width
B4 width
B4/A3 width
(Switch by FAX soft SW)
A3 width
0: A3(A3•B4•A4) width
0: Follows the date format.
0:Added
0: Outside of document
USA Initial value Key
operator
0 Collectively
outputted
0
0 Reduction Receive
setup
1 Dispose
0 90%
0
0
0
0
1
0
1
0 By installed
cassette
0
0 A3 width
0 Follows the
date format.
0 Added Send setup
0 Outside the Send setup
document