Sharp AR-FX12 Service Manual page 34

66-33
Purpose Setup
Function (Content) Used to check signal detection.
Section FAX
Item Operation
Operation/Procedure When the signal is detected, the display is
highlighted.
(This mode is for production check, and inhibited in the market.)
SIMULATION 66-33
SIGNAL DETECT CHECK.
BUSY TONE CNG CED FNET
66-34
Purpose Setup
Function (Content) Used to measure and display the communication
time.
Section FAX
Item Operation
Operation/Procedure The time spent for communication is measured.
Send/receives are performed in the Standard
mode.
The communication time is displayed with the
simulation. (unit: ms)
SIMULATION 66-34
COMMUNICATION TIME DISPLAY.
***** ms
<Setup for send>
Communication means
Image quality
Density
ECM
Sender record
DTMF
memory transmission
Normal
Thin
ON
OFF
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-22
66-35
Purpose Operation test, check
Function (Content) Modem program rewriting.
Section FAX
Item Operation
Operation/Procedure The modem program in the FAX program is
rewritten.
1) Select with 10 digit key pad and press START
to execute the following.
1: MODEM program rewrite
2:Not clear
2) Check the loader check sum value.
If it is OK, the test is normally completed.
If NG, the check sum value
(1 byte = hexadecimal) is displayed.
3) If the loader is NG, the MODEM result is also
NG.
4) The Modem rewrite result is displayed.
SIMULATION 66-35
MODEM PROGRAM RELOAD.
ARE YOU SURE ?
1. YES
2. NO
Press [START] key.
SIMULATION 66-35
MODEM PROGRAM RELOAD. EXECUTING...
LOADER...(OK or Check Sum value 1 byte (Hexadecimal))
MODEM...(COMPLETE or NG code 1 byte (Hexadecimal))
After completion of writing
SIMULATION 66-35
MODEM PROGRAM RELOAD.
LOADER...OK
MODEM...COMPLETE
<Result of MODEM writing>
COMPLETE
81
82
83
84
NG
1
Writing completed
Check sum error
Write error
Delete error
Verify error
Due to loader error