Sharp AR-FX12 Service Manual page 30

66-13
Purpose Setup
Function (Content) Used to enter (set) the number for the FAX dial
signal output test. (The dial number signal set
with this simulation is outputted in the dial signal
output test with SIM 66-14~16)
(Only when FAX is installed.)
Section FAX
Item Data
Operation/Procedure The dial test number is set.
Enter a number with 10 digit key pad, * key, and
# key.
The upper limit is 20 digits.
Press CLEAR to return to the initial state.
Press START to register.
SIMULATION 66-13
DIAL TEST NUMBER SETTING.
INPUT NUMBER AND PRESS START.
0123456789*#01234567
66-14
Purpose Setup
Function (Content) Used to set the make time in the FAX pulse dial
mode (10PPS) and to test the dial signal output.
(The dial number signal set with SIM 66-13 is
outputted.)
Used to check dialing troubles and the operation.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure The dial test is performed. (10PPS output)
The make time is set. (Set range : 0-15)
When CUSTOM SETTING is pressed, the
execution is terminated.
SIMULATION 66-14
DIAL TEST(10PPS). SELECT 0-1, AND PRESS START.
0. EXECUTE
; [ ms]
7 +29
1.MAKE TIME
Select 0 and
Select 1 and press [START] key. Press [CUSTOM SETTINGS] key
press [START] key.
SIMULATION 66-14
DIAL TEST(10PPS). SELECT 0-15, AND PRESS START.
[1.MAKE TIME]
SIMULATION 66-14
DIAL TEST(10PPS). EXECUTING...
; [ +29 ms]
7
1.MAKE TIME
<List of set values>
0 Execution
1 Dial pulse make time setup (0 - 15)
* Dial is send with the setup value of +29ms.
0-9:[0-9], *:[*], #:[ ]
#
1
or [START] key.
7
Press [CUSTOM SETTINGS] key.
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-18
66-15
Purpose Setup
Function (Content) Used to set the make time in the FAX pulse dial
mode (20PPS) and to test the dial signal output.
(The dial number signal set with SIM 66-13 is
outputted.)
Used to check dialing troubles and the operation.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure The dial test is performed. (20PPS output)
The make time is set. (Set range : 0-15)
When CUSTOM SETTINGS is pressed, the
execution is terminated.
SIMULATION 66-15
DIAL TEST(20PPS). SELECT 0-1, AND PRESS START.
0. EXECUTE
; [ ms]
+9
7
1.MAKE TIME
Select 0 and
Select 1 and press [START] key. Press [CUSTOM SETTINGS] key
press [START] key.
SIMULATION 66-15
DIAL TEST(20PPS). SELECT 0-15, AND PRESS START.
[1.MAKE TIME]
SIMULATION 66-15
DIAL TEST(20PPS). EXECUTING...
; [ ms]
7 +9
1.MAKE TIME
<List of set values>
0 Execution
1 Dial pulse make time setup (0 - 15)
* Dial is send with the setup value of +9ms.
1
or [START] key.
7
Press [CUSTOM SETTINGS] key.