Sharp AR-FX12 Service Manual page 50

SW Bit Item
No. No.
37 7 Page number print
8 Not used
38 1,2 Protocol monitor
3 Line monitor display
4-8 Time print (o'clock) on
the communication
report table
39 1 Communication report
table printing at the
specified time
2-7 Time print (min) on the
communication report
table
8 Automatic print of
communication report
table at memory full
40 1 Print of total
communication time on
the communication
report table
2 Report output (when in
receive rejection)
<FAX only>
3 Sent document print in F
code communication
4 Report output
(When canceling)
Switch selection and function
Used to set whether the page number is added at the date/sender information
print position or not. (Page number/Total page number in case of memory
transmission)
1: Not added
Used to set whether the protocol monitor (which is recognized by the FAX) for
one communication is printed or not.
When a new communication is made before printing the protocol monitor, the
old protocol data are deleted. (Overwriting)
Bit No.
NO (Not print)
NO (Not print)
Print (Always)
Only in an error (Print)
Used to set whether the communication speed during communication and the
reception level during reception are displayed on the LCD or not.
1: Displayed on LCD
Used to set the time print (o'clock) when time is printed on the communication
report table. The set range is 0 - 23 o'clock by binary input. If a value of 24 - 31
is inputted, it is set to 0 o'clock.
Used to set whether the communication report table is outputted at the
specified time or not.
Though time specification print is enabled, if the specified time is in the
nighttime FAX mode, output is not made.
1: Communication report
table is printed at the
specified time.
Used to set the time print (min) when time is printed on the communication
report table.
The set range is 0 - 59min by binary input. If a value of 60 - 63 is inputted, it is
set to 0 min.
Used to set whether the communication report table is automatically outputted
or not when the number of send/receive items reaches 50 items.
1: Automatic print
If the report is not outputted, the oldest data are overwritten.
Used to set whether the total communication time and the total number of
pages are printed on the communication report table or not.
1: Not print 0: The total time and the total number of
pages are printed.
Used to set whether the communication report is outputted or not when FAX
receive is set to "receive reject." However, report output (in receive) must be set
to "Not print."
1: Printed
Used to set whether part of the sent document is printed or not on the
communication report table in F code communication. The setup of SW41-1
and SW41-2 has priority over this setup.
1: Sent document is
printed.
Used to set whether the communication report table is outputted or not when
transmission is canceled during transmission of document.
1: Communication report
table is printed.
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-38
0: Added
1 2
0 0
0 1
1 0
1 1
0: Not displayed on LCD
0: Communication report
table is not printed at
the specified time.
0: Not print
0: Not printed
0: Sent document is not
printed.
0: Communication report
table is not printed.
USA Initial value Key
operator
0 Added Send setup
0
0 NO
0
0 Not
displayed
0 0 o'clock Initial setup
0
0
0
0
0 Not output Initial setup
0 0 min Initial setup
0
0
0
0
0
0 Not output Initial setup
0 Print
0 Not printed
0 Not printed.
0 Not output