Sharp AR-FX12 Service Manual page 31

66-16
Purpose Setup
Function (Content) Used to test the dial signal (DTMF) output in the
FAX tone dial mode. (The dial number signal set
with SIM 66-13 is outputted.)
The send level can be set to an optional level.
Used to check dialing troubles and the operation.
Section FAX
Item Operation
Operation/Procedure The dial test is performed. (DTMF signal output)
1) The level (dB) setup is made.
(Set range: 0 - 15dB)
2) The difference between high group and low
group is set. (Set range: 0 - 15)
3) When CUSTOM SETTING is pressed,
the execution is terminated.
* For the set value, refer to the soft SW specifications.
SIMULATION 66-16
DIAL TEST(DTMF). SELECT 0-2, AND PRESS START.
0. EXECUTE
7
1.HIGH (dB) 2.
Select 1 or 2 and press [START] key. Press [CUSTOM SETTINGS] key
(When 1 is selected)
SIMULATION 66-16
DIAL TEST(DTMF). SELECT 0-15, AND PRESS START.
1.HIGH (dB)
(When 2 is selected)
SIMULATION 66-16
DIAL TEST(DTMF). SELECT 0-15, AND PRESS START.
2. HIGH-LOW
Select 0 and
press [START] key.
(When 0 is selected)
SIMULATION 66-16
DIAL TEST(DTMF). EXECUTING...
1.HIGH 7 (dB) 2.
<List of set values>
0 Execution
1 HIGH High group level
2 HIGH-LOW High group - low group
For the set values, refer to the soft SW specifications.
HIGH-LOW
7
or [START] key.
Press [CUSTOM SETTINGS] key.
HIGH-LOW
7
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-19
66-17
Purpose
Function (Content)
Section
Item
Operation/Procedure The DTMF signal output is checked.
SIMULATION 66-17
DTMF SIGNAL OUTPUT.(LEVEL MAX) INPUT 0 9,* ,#, AND PRESS START.
Press [START] key.
SIMULATION 66-17
1
DTMF SIGNAL OUTPUT.(LEVEL MAX) EXECUTING...
<DTMF signal>
1 - 9, 0, *, #
7
66-18
Purpose
Function (Content)
7
Section
Item
Operation/Procedure The DTMF signal output is checked.
SIMULATION 66-18
DTMF SIGNAL OUTPUT.(SOFT SW) INPUT 0
Press [START] key.
SIMULATION 66-18
DTMF SIGNAL OUTPUT.(SOFT SW) EXECUTING...
<DTMF signal>
1 - 9, 0, *, #
Setup
Used to test the dial signal (DTMF) output in the
Fax tone dial mode. Send level Max.
Used to check the dial IC operation.
(Only when FAX is installed.)
FAX
Operation
(Output level 0)
When CUSTOM SETTING is pressed,
the execution is terminated.
Press [CUSTOM SETTINGS] key.
Setup
Used to test the dial signal (DTMF) output in the
Fax tone dial mode.
The send level set with the soft switch is
outputted.
Used to check the dial IC operation.
(Only when FAX is installed.)
FAX
Operation
(Output level is set with soft SW.)
When CUSTOM SETTING is pressed,
the execution is terminated.
9,* ,#, AND PRESS START.
Press [CUSTOM SETTINGS] key.
1
1
1
1