Sharp AR-FX12 Service Manual page 33

66-23
Purpose Operation test, check
Function (Content) Used to download the FAX program.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure The contents of ROM in the option memory
(AR-MM9) installing section are copied as FAX
program.
(This mode is for development, and inhibited in the market.)
SIMULATION 66-23
FAX PROGRAM DOWNLOAD.
EJECT PROTECT PIN, AND PRESS START.
Press [START] key.
SIMULATION 66-23
FAX PROGRAM DOWNLOAD. EXECUTING...
After normal completion of writing
SIMULATION 66-23
FAX PROGRAM DOWNLOAD.
COMPLETE
POWER OFF, AND SET PROTECT PIN
SIMULATION 66-23
FAX PROGRAM DOWNLOAD.
FAIL
CHECK PROTECT PIN
66-24
Purpose Operation test, check
Function (Content) Used to clear the FAST memory data.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure 1) Select with 10 digit key pad, press START to
execute the following.
1: Fast memory data clear
2: Not clear
SIMULATION 66-24
FAST MEMORY DATA CLEAR.
ARE YOU SURE ?
1. YES
2. NO
66-29
Purpose Setup
Function (Content) Used to clear the Address data.
Section FAX, NWS
Item Operation
Operation/Procedure 1) Select with 10 digit key pad and press START
to execute the following.
1: Address data clear
2: Address data not clear
SIMULATION 66-29
ADDRESS DATA CLEAR.
ARE YOU SURE ?
1. YES
2. NO
After failure of writing
1
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-21
66-30
Purpose Setup
Function (Content) Used to check TEL/LIU status change.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure The TEL/LIU status can be checked.
The display is highlighted when the status is
changed.
SIMULATION 66-30
TEL/LIU SENSOR CHECK.
HS1 HS2 RHS EXHS
<List of set values>
HS1 Polarity reverse signal
HS2 Polarity reverse signal
RHS Handset hook SW
EXHS External telephone hook SW
66-31
Purpose Setup
Function (Content) Used to set the TEL/LIU status.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure Entry of only 0 or 1 is effective.
Shift the cursor to the bit to enter.
Cursor shift keys :
The bits are 1, 2, 3, 4, 5, 6, 7, and 8 from the left.
The entered bit is highlighted.
Press STRT to select the relay.
SIMULATION 66-31
TEL/LIU SETTING.
INPUT 0 - 1, AND PRESS START.
MOVEMENT LEFT: [*] RIGHT: [#]
MPXA
1. 2.CION 3. MR
S.
5. 6. 7. DP
CML
66-32
Purpose Setup
Function (Content) Used to check the received data.
(Only when FAX is installed.)
Section FAX
Item Operation
Operation/Procedure The fixed data received from the line are
checked.
(This mode is for production check, and inhibited in the market.)
SIMULATION 66-32
RECEIVED DATA CHECK.
CHECKING...(OK or NG)
<Display message>
CHECKING Checking
OK Checking complete (Coincided)
NG Checking end (Not coincided)
: * , : #.
1 2 3 4 5 6 7 8
10001100
4. EC
8.