Sharp AR-FX12 Service Manual page 42

SW Bit Item
No. No.
9 7,8 Not used
10 1-4 Ring back tone ON time Used to set the pseudo-ringing to an external telephone and the ring back tone
5-8 Ring back tone OFF
time
11 1-4 Image quality priority
selection (Standard
image quality setup)
5 Automatic wake up
mode
6 Not used
7 Image quality setup
when saving(FAX)
8 Selection of resend
page in case of an error
12 1-8 External telephone off-
hook detection time
13 1-8 Remote switch number
setup
14 1 Remote reception
instruction
Switch selection and function
ON time to the line.
Setting can be made in the range of 0 ~ 3sec in the increment of 200ms.
When set to 0, however, same as setting to 1sec.
Used to set the pseudo-ringing to an external telephone and the ring back tone
OFF time to the line.
Setting can be made in the range of 0 ~ 3sec in the increment of 200ms.
When set to 0, however, same as setting to 2sec.
When set to less than 2sec, busy tone may be erroneously detected.
Used to set the initial setting of image quality selection when scanning a
document by FAX. When set to "0100," "1000," "1001" and later, the same
operation is made as normal characters.
Bit No.
Normal text
Fine
Super fine
Ultra fine
Fine (Half tone)
Super fine (Half tone)
Ultra fine (Half tone)
Used to set whether the machine is automatically wake up and the received
document is outputted or the received document is saved in memory and will be
outputted when the power is turned on next time when a FAX message is
received with the main SW ON and the FAX power SW ON or in the power save
mode.
1: Saved in memory
without booting
machine
Used to set whether the initial setting is set to Enable of the image quality of
filed documents when FAX-sending filed documents.
1: Applied
Used to select resend pages in case of an error in transmission without F code.
1: All pages
(Resend all pages from the
first page including
transmitted pages.)
If transmission includes F code, all pages are resent.
Used to set the time to recognize external telephone off-hook detection.
The set range is 0ms - 255ms in the increment of 10ms by binary input.
Used to set the number for remote switch receive from an external telephone by
binary input.
However, remote switch numbers of "XX*" and "*" are fixed.
When set to "C" (BCD) or above, same as setting to the initial value of "5"
(BCD).
55 (Japan)
Used to set YES/NO of remote switch from an external telephone.
1: NO (remote switch
disable)
AR-FX12 SIMULATIONS, FAX SOFTWARE SWITCH 6-30
1 2 3 4
0 0 0 0
0 0 0 1
0 0 1 0
0 0 1 1
0 1 0 1
0 1 1 0
0 1 1 1
0: Output by automatic
booting of machine
0: Not applied
0: After error page
(Resend after error
page)
5* (Outside Japan)
0: YES (Remote switch
enable)
USA Initial value Key
operator
0
0
0 1sec
1
0
1
1 2sec
0
1
0
0 Normal text Operation
setup
0
0
0
0 Output Initial setup
0
0 Not applied Operation
setup
0 After the
error page
0 300ms
0
0
1
1
1
1
0
0 5* Initial setup
1
0
1
1
0
1
0
0 YES