Table of Contents
Advertisement
17 TUNING THE ENGINE
17.3
116
Adjusting the play in the throttle cable
Info
If the correct routing of the throttle cables has already been secured, the fuel tank does not need to be
removed.
S05548-10
Danger
Danger of poisoning Exhaust gases are toxic and inhal-
ing them may result in unconsciousness and death.
–
Always make sure there is sufficient ventilation
when running the engine.
–
Use effective exhaust extraction when starting or
running the engine in an enclosed space.
–
Start the engine and let it run at idle speed. Move the handle-
bar to and fro over the entire steering range.
The idle speed must not change.
»
If the idle speed changes:
–
Adjust the play in the throttle cable.
Preparatory work
–
Remove the seat. (
p. 62)
–
Remove the fuel tank.
–
Check the throttle cable routing. (
Main work
–
Move the handlebar to the straight-ahead position.
–
1
Push back sleeve
.
–
2
Loosen nut
.
–
3
Turn adjusting screw
–
4
Loosen nut
.
–
6
Push cold start button
–
5
Turn adjusting screw
the basic position when the throttle grip is turned to the front.
–
4
Tighten nut
.
–
3
Turn adjusting screw
cable at the throttle grip.
Guideline
Play in throttle cable
–
2
Tighten nut
.
–
1
Slide on sleeve
.
–
Check the throttle grip for smooth operation.
Finishing work
–
Check the play in the throttle cable. (
–
Install the fuel tank.
(
–
Mount the seat. (
p. 62)
(
p. 116)
(
p. 70)
p. 78)
in as far as possible.
all the way to the stop.
so that the cold start button moves to
so that there is play in the throttle
2 ... 3 mm (0.08 ...
0.12 in)
p. 115)
p. 72)
Advertisement
Table of Contents
