Camshaft Installation - Honda 1988 Z50R Service Manual

Install the cylinder head and tighten the cylinder head mounting
bolt loosely.
Instal! the gasket and the right side cover.
Install the cylinder head cover.
NOTE
Install the cylinder head cover with the arrow facing the ex-
haust side as shown.
Note the positions of the copper washer and the flange nut in the
picture at right. Tighten the nuts and washers in a criss cross
pattern in 2 or 3 steps to the specified torque.
Then tighten the cylinder head mounting bolt.
TORQUE : 11 N'm 11. 1 kg -m , 8 fl-tbl
NOTE
Be careful not t o mistake the position of the copper washer
and flange nut.
CAMSHAFT INSTALLATION ('88-'91)
Align the "T" mark on the flywheel with the index mark on the
left crankcase by turning the crankshaft counterclockwise.
Install the camshaft .
COPPER
CYLINDER HEAD/VALVES
ARROW
CYLINDER HEAD
Me'UN'T"'G BOLT
NUT
6 -15