Float Level Inspection; Throttle Valve Assembly - Honda 1988 Z50R Service Manual

FUEL SYSTEM
FLOAT LE VEL INSPECTION
Measure the float level with the float t ang just touching the f loat
valve.
FLOAT LEVEL : 12.7
mm (0 .5 in)
Replace the float if the level does not meet t he specification.
TOOL: Carburetor float level gauge
07401 - 0010000
Check the O-rings for wear or f atigue .
Install the float chamber and tighten the two screws.
THROTTLE VALVE ASSEMBLY
Install the needle clip on the jet needle.
STANDARD GROOVE POSITION : 2nd
Install the jet needle int o the throttle valve and secure it wit h t he
needle clip retainer.
Connect t he t hrottle cable to the th rottle va lve while depressi ng
the valve spring .
4-8
~
NEEDLE CLIP
~
RETAINER
JET NEEDlE--
TH ROTTLE_A
VALV E
llJ
THROTTLE CAI"E
THROTTLE
NEEDLE CLIP
VALVE SPRIN G