Float And Jets Disassembly - Honda 1988 Z50R Service Manual

FUEL SYSTEM
FLOAT AND J ETS DI SA SSEMBLY
Remove the float chamber from the carburet or body.
Loosen the screw and remove the float pin, then remove the float
and float valve .
Check the float for deformat ion or the presence of f uel, and
replace
if
necessary .
Inspect the float valve and seat for wear or damage.
Replace the ftoal valve if it is damaged.
If the seat is damaged, replace the carburetor body.
Remove the main jet, needle jet holder, and throttle stop screw.
NOTE
Before removing the air screw, record the number of turns until
the screw seats lightly; then remove the air screw .
CAUTION
The oir scre w seal will be (Iall/aged If the screw is lighlenel/ againsf
the scm.
Clean the carburetor body passages with compressed air.
Check each part for wear or damage and replace them
jf
necessary .
4-6
N EEDLE J ET HOLOE' R
THR OTTLE STOP SC" EW