Honda 1988 Z50R Service Manual page 126

REAR WHEE L/ BRAKE/ SUSPENSION
Inspect the sprocket teeth for excessive wear or damage.
Replace if necessary.
NOTE
Never install a new drive chain on worn sprockets or a worn chain
on new sprockets. Both chain and sprockets must be in good con -
dition, or the new replacement chain or sprockets will wear
rapidly.
Turn the inner race of each bearing with your finger. The bear-
ings should turn smoothly and quiet ly. Also check that the bear-
ing outer race fits tightly in the hUb.
Remove and discard the bearings
if
the races do not turn smooth-
Iy, quietly, or if they fit loosely in the hub.
NOTE
Replace hub bearings in pairs.
BEARING REPLA CEMENT
Insert the bearing remover head into the bearing.
From the opposite side install the beating remover shaft and drive
the bearing out of the wheel.
Remove the distance collar and drive out the other bearing and
dust seal.
TOO LS:
Bearing remover shaft
Bearing remover head 12 mm
07746 - 00500100
.,
equivalent commerciallv
available in U .S.A.
07746 - 00500300
.,
equivalent commercialiV
available in U
.S.A.
Pack the new bearing cavit ies with grease.
Drive a new left bearing in squarely with the sealed side facing out.
Install the distance collar into place.
NOTE
Be certain the distance collar is in position before installing the
right bearing.
Drive a new right bearing in squarely with the sealed side facing
out.
Drive in a new dust seal.
TOOLS:
Driver
Attachmet. 32
x
35 mm
Pilot 12 mm
12-4
07749 - 0010000
07746 - 0010100
07746 - 0040200
o
~
GOOD NOT GOOD