Husqvarna TE 250 Workshop Manual page 368

"KIT" ASSEMBLING INSTRUCTIONS
Reassemble clutch discs (8), clutch control cap (9), pressure plate (10) and springs
(11).
Tight the clutch springs screws (12) whilst following a cross-over pattern and in steps
(5 mm allen wrench: 8 Nm-0,8 Kgm- 5.8 ft/lb).
Reassemble R. H. crankcase cover gasket, reassemble cover and tighten 12
fastening screws at 8 Nm-6 ft/lb (8 mm wrench). Reassemble oil line bolt on
crankcase cover (13 mm wrench; tighten at 15 Nm-1,5 kgm-11 ft/lb). Pour the
proper oil amount in the crankcase (1,5 l.-1.3 Imp. Quarts- 1.6 U.S. Quarts of
AGIP RACING 4T/ 10W-60).
O.26 Part. N. 8000 B0148 (02-2008)