GENERAL OPERATIONS
9) For the rear chain disassembling (both of the chain type without O-Rings
that with rings O-Rings), remove the clip (1), the master link (2) then the chain.
Using a 12 mm wrench on the L.H. side and a 10 mm wrench on the R.H. side,
remove fastening bolts (3) (engine-frame).
Remove the upper clamp (5) of the shock absorber.
Remove the guards (4) by removing the clamp to the frame; use a 22 mm wrench
on the left side, unscrew the nut from the fork pin, extract the axle from the R.H.
side then pull back the rear swing arm in order to facilitate the engine disassem-
bly from the frame.
Lift the engine, slope it on the L.H. side and remove it from the motorcycle.
Place the engine on a turning stand in order to operate as shown on chapters F-
G-H.
3
5
4
E.14
Part. N. 8000 B0148 (02-2008)