Husqvarna TE 250 Workshop Manual page 383

Remove the left radiator grid.
Remove the three hexagonal screws holding the left radiator.
Remove the three fuse housings located on the right side back frame. Before
removing them from the support bracket, unfasten them by means of a
screwdriver .
Remove the fall sensor by unscrewing it from the anchor bracket. The TE
versions are NOT equipped with this sensor and use a plug to interface with the
cables and simulate their presence.
Part. N. 8000 B0148 (02-2008)
"KIT" ASSEMBLING INSTRUCTIONS
O.41
LOOSEN THE RADIATOR LEFT
REMOVING FUSE HOUSINGS
REMOVING THE FALL SENSOR (SMR version only)