Replacing The Muffler Deadening Material (Smr 450-R) - Husqvarna TE 250 Workshop Manual

SETTINGS AND ADJUSTMENTS

Replacing the muffler deadening material (SMR 450-R)

Remove the saddle after turning the locking back pin (1) anticlockwise, loosen the
1
screws (2) with an 8-mm T-shaped spanner and remove the side panel (3) (do the
same on the right side). Using an 8 mm T-shaped spanner on the outside and a
10 mm T-shaped spanner on the inside, remove the locking screw (4) of the
muffler. Remove the spring (5) and pull out the muffler (A) o (B). Remove the four
rear rivets (6), clamp and the exhaust terminal (7). Remove innner pipe and
replace the deadening material. Reassemble L.H. side panel and saddle.
: When diffuculties are found in removing the muffler, lightly beat with
a rubber or plastic hammer.
2
2
3
7
6
4
A
6
A
4
7
B
5
B
D.38 Part. N. 8000 B0148 (02-2008)