Husqvarna TE 250 Workshop Manual page 362

"KIT" ASSEMBLING INSTRUCTIONS
10- Electric starter kit (TC: drawing A+B)
To effect the above mentioned operations, it is not necessary to remove the engine from the motorcycle.
The electric starter kit consists of:
DRAWING "A"
1- Starting motor (1)
2- Screw M6x25 (2)
3- Gear Z=24 (1)
4- Free wheel (1)
5- Disc (1)
7- Pin (1)
9- Plate (1)
11- Screw M6x16 (4)
12- Spacer (1)
16- Nut (1)
27- Gear Z=70 (1)
28- Needle bearing (1)
29- Washer th. 1.5 mm (1)
30- Spacer (1)
31- Electric start clutch (1)
32- Washer th. 0.5 mm (2)
33- Spacer (2)
DRAWING "B"
3- Clamp L=188 mm (8)
4- Clamp L=142 mm (5)
6- Battery fastening belt (1)
7- Battery 6 Ah (1)
8- Voltage rectifier (1)
9- Battery-Ground cable (1) (L=890mm)
10- Screw M6x20 (2)
11- Battery plate fastening rivet(4)
12- Battery belt fastening plate (2)
13- Condenser (1)
14- Battery-solenoid starter cable (1) (L=160mm)
15- Starting motor cable (1) (L=600mm)
16- Solenoid starter (1)
17- Screw M6x8 (2)
18- 15A fuse (2)
24- Clutch microswitch (1)
28- Engine stop switch (1)
29- Engine start switch (1)
O.20 Part. N. 8000 B0148 (02-2008)