Husqvarna TE 250 Workshop Manual page 83

GENERAL OPERATIONS
4) TC-TXC: Loosen the clamps (3) and (4) that fasten the carburetor to the
4
intake manifold and air filter box manifold. Pull back the carburetor to free it from
the intake manifold and extract the carburetor from the right side of the motorcy-
cle. Remove the carburetor floater chamber lower screw (5), the floater cham-
ber then eliminate the remaining gasoline.
3
5
4) TE-SMR: loosen the left clamp (1) of the sleeve on the throttle body and the
front clamp (2) on the cylinder head. Disconnect the connector from the M.A.Q.S.
7
(6) on the throttle body of the main cable. Remove the throttle body (7); when 2
reassembly the throttle body, adjust the T.P.S. again (see chapter S).
1
6
Remove the fastening pin (8) and the rear brake pedal.
8
Part. N. 8000 B0148 (02-2008) E.9