Husqvarna TE 250 Workshop Manual page 369

On the right side of the panel, assemble the plate (12) by means of the relevant rivets (11) matching the holes already present in the
frame. Insert the battery (7) into the frame.
Insert the battery (7) into the holder. Assemble the solenoid starter (16) and fasten the cables (14) and (15) to the battery and to the
solenoid starter using the screws (17) M6x8. Lock the battery with the elastic (6). Place the cable (15) on the L.H. side of the frame and
mount the clamps (4) and (3) as shown in the figure. Assemble the starting motor (1) and fasten it with the screws (2) (on the R.H. screw
fasten the cable 9 too). Fasten the cable (15) (rubber cap side) on the starting motor too. Assemble the condenser (13) on the frame.
11
12
4
1
9
Part. N. 8000 B0148 (02-2008)
"KIT" ASSEMBLING INSTRUCTIONS
7
4
6
16
14
15
2
O.27
15
1