Husqvarna TE 250 Workshop Manual page 364

"KIT" ASSEMBLING INSTRUCTIONS
PRELIMINARY OPERATIONS
Remove the seat (page E.15);
- remove the side panels, the exhaust system, the fuel tank and the conveyors (pages E.16, E.20, E.23);
- remove the front number holder (5) (remove the screw 1, the hose clamp 2 and the upper screw 4);
- drain the engine oil (page D.17) and reassemble the engine oil drain plug (8 mm allen wrench; tighten at 25 Nm-18.5 ft/lb).
Remove oil line bolt on R.H. crankcase cover (13 mm wrench).
Remove 12 cover fastening screws (8 mm wrench ), cover and
gasket.
O.22 Part. N. 8000 B0148 (02-2008)