Konica Minolta bizhub pro 1050 User Manual page 114

Troubleshooting Tips (continued)
THE ORIGINAL PAPER IS MISHANDLED OR SKEWED IN THE DOCUMENT FEEDER
Originals should conform to the recommended size and weight.
Be sure originals are not stapled.
Align originals evenly in the ADF.
Check to make sure paper guides meet the width of mixed size originals.
ADF CANNOT BE USED AFTER [Reset] IS PRESSED
Fully close ADF.
Originals should conform to the recommended size and weight.
Position originals properly in the ADF.
Set to use ADF in the Initial Setting. See POD Administrator's reference for details.
FINISHER/FOLDING UNIT DOES NOT OPERATE
Check for a paper misfeed and remove it, as required.
Properly close finisher door/Folding unit door.
ADD TONER MESSAGE IS DISPLAYED
New toner supply is needed. Follow instructions for adding toner.
CALL FOR PM IS DISPLAYED IN MESSAGE AREA
Contact your service representative for Preventive Maintenance.
APS SELECTS THE WRONG PAPER SIZE
Paper guides must be adjusted exactly to the size of originals.
IN MIXED ORIGINAL MODE, A MESSAGE TO LOAD A REQUIRED PAPER SIZE
DISPLAYS, EVEN THOUGH THAT SIZE IS LOADED IN ONE OF THE TRAYS
Paper sizes loaded in the trays must be consistent with the tray position size;
otherwise, the tray key on the Copy Screen will blink.
THE COPY SCREEN DOES NOT DISPLAY SETTINGS AS DESCRIBED IN
USER'S GUIDE
Check with the machine manager, as Initial Settings may have been changed.
"PLEASE CHECK ORIGINAL"
This message appears when the copier detects a non-standard paper size on the
original glass.
Select paper size and press [Start]. 1.000 magnification will be selected automatically.
If this message continues to be displayed after selecting paper size, select 1.000
magnification, even if it is already indicated, then press [Start]. If desired, ask your
service representative to enable the machine to default to 1.000 magnification in this
situation.
SHEET INSERTION RESULT IS NOT AS EXPECTED
Blank insertion: Be sure manuscript originals do not already include blank sheets in
the locations designated for sheet insertion.
Print insertion: To ensure that chapter sheets in 1-2 mode always appear on the right
hand side in the finished set, insertion sheets must be designated on the page
setting screen with odd numbers, not even. If required, make an even numbered
original page odd by inserting a blank sheet in front of that page, so that the blank
sheet is even and the insertion sheet is odd.
5-16