Konica Minolta bizhub pro 1050 User Manual page 101

If "Please Call Service" Message Is Displayed (continued)
4.
Contact your service representative and report the condition and
report code number.
DETAILS: Limited Use of the Copier in Trouble
If the message shown below is displayed on the Call for Service Screen, you
may continue operating the copier on a limited function basis and utilize the
trays and ADU that are not affected by the trouble. To obtain this limited
functionality of the copier, consult your service representative. Be sure to
utilize the limited function only temporarily, and arrange for machine repair
immediately.
1. If the limited use of the copier is available, the following message is
displayed in the message area instead of the report code.
ex. -- Tray 2 failure --
Press Reset to select except this tray
2. Press [Reset].
Please switch Off/On
E 18-2
Make note of the report code.
3. Turn OFF then ON the sub power switch.
A copying job can continue without using the troubled portion of the
machine (ex. Tray 2).
EVEN IF THE COPYING JOB CAN BE CONTINUED WITH THE ABOVE
OPERATION, BE SURE TO CONTACT YOUR SERVICE REPRESENTATIVE
IMMEDIATELY WHEN THE CALL FOR SERVICE SCREEN IS DISPLAYED.
5-3