KYMCO 2006 MXU 500 Off-Road Owner's Manual page 550

15.
REAR WHEEL/AXLE/SHOCK
ABSORBER/SWING ARM
INSTALLATION
Install the wheel hub and nut.
＊
Apply lightweight lithium-soap base
grease onto the wheel hub splines, rear
axle splines and dust seal lips of the axle
housing.
Apply the front brake and then tighten the
nut to the specified torque.
Torque: 10 kgf-m (100 N-m, 72 lbf-ft)
Install the cotter pin and band ends of cotter
pin.
＊
Do not apply oil to the seat of the nut.
Do not loosen the wheel hub nut after
torque tightening. If the wheel hub nut
groove is not aligned with the cotter
pin hole, align groove with the hole by
tightening up on the wheel hub nut.
＊
Always use a new cotter pin.
15-5
Apply grease
Apply grease
Cotter Pin
MXU 500
Nut