KYMCO 2006 MXU 500 Off-Road Owner's Manual page 390

10. DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
Place a block on the plate nut.
Compress the spring by using a
commercially available puller, install the
drive belt.
＊
The drive belt should be installed so
that the arrows on the drive belt
periphery point in the normal turning
direction.
The drive belt contact surface of the
driven face should be thoroughly
cleaned.
Install the driven pulley assembly and drive
V-belt.
Use the special tool to hold driven pulley,
then tighten the nut to the specified torque.
Torque: 10 kgf-m (100 N-m, 72 lbf-ft)
Special tools:
Y-type holder
Apply lubricant to the drive face boss inner
surface, then install the drive pulley.
10-7
Apply oil to the threads
A120E00056
Block
Nut
Y-type Holder
Apply lubricant
Drive Face Boss
MXU 500