KYMCO 2006 MXU 500 Off-Road Owner's Manual page 590

16
. BRAKE SYSTEM
Remove fluid hose bolt/two washers and
then disconnect the fluid hose.
＊
When removing the brake fluid hose
bolt, be sure to place towels under the
hose and plug the hose end to avoid
brake fluid leakage and contamination.
Remove the two mounting bolts and remove
the master cylinder.
INSPECTION
Check the diaphragm to cracks or damage.
If any damages are found, replace the
diaphragm with a new one.
INSTALLATION
Front/rear master cylinder
Install the brake light switch.
Place the right and left brake master
cylinder on the handlebar and install the
master cylinder holder with the "UP" mark
facing up, aligning the punch mark on the
handlebar with the holder joint seam. First
tighten the upper bolt and then tighten the
lower blot.
Torque: 1.2 kg-m (12 Nm, 8.6 lbf-ft)
16-25
MXU 500