Combination Brake Fluid Chang - KYMCO 2006 MXU 500 Off-Road Owner's Manual

16
. BRAKE SYSTEM
COMBINATION BRAKE FLUID
CHANGE/AIR BLEED (ON
ROAD)
BRAKE FLUID CHANGE
Place the machine on the level ground and
set the handlebar upright.
1. Remove the two screws from the brake
fluid reservoir cap.
2. Remove the brake fluid reservoir cap
(front brake lever).
＊
Use shop towels to cover plastic parts
and coated surfaces to avoid damage
caused by splash of brake fluid.
3. Connect a transparent hose to the delay
valve bleed valve and then loosen the
bleed valve nut. Use a syringe to draw the
brake fluid out through the hose. Then
tighten the bleed valve nut.
Torque: 0.6 kgf-m (6 Nm, 4.32 lbf-ft)
16-17
Cap
MXU 500
Bleed Valve