KYMCO 2006 MXU 500 Off-Road Owner's Manual page 191

1
. GENERAL INFORMATION
Route harnesses so they are neither
pulled tight nor have excessive slack.
Protect wires and harnesses with electrical
tape or tube if they contact a sharp edge or
corner.
When rubber protecting cover is used to
protect the wire harnesses, it shall be
installed securely.
Do not break the sheath of wire.
If a wire or harness is with a broken sheath,
repair by wrapping it with protective tape or
replace it.
When installing other parts, do not press or
squeeze the wires.
Do not pull
too tight!
Do not press or
.
squeeze the wire
MXU 500
1-8