10. DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
DRIVE PULLEY, DRIVE V-BELT
AND DRIVEN PULLEY
REMOVAL/INSPECTION/
INSTALLATION
REMOVAL
Use the special tool to hold the drive pulley,
then remove the nut and washer.
Special tool:
Drive pulley holder
Remove the drive pulley.
Use the special tool to hold the driven
pulley, then remove the nut.
Special tool:
Y-type holder
Remove the driven pulley and V-belt.
Remove the driven pulley washer.
Remove the drive pulley face.
*
Do not loosen the stopper lever shaft nut,
it may cause stopper lever bolt loosen.
To tighten the stopper lever bolt must
remove the crankcase (refer to the
"TRANSMISSION REMOVAL/
INSPECTION/INSTALLATION"
section in the chapter 11).
10-5
A120E00058
A120E00056
Drive Pulley Holder
Drive Pulley
Nut/Washer
Nut
Y-type Holder
Drive Pulley Face
Stopper Lever Shaft Nut
MXU 500
Washer