Dsl Status - NetComm IP DSLAM NCT480 User Manual

DSL Status

The line status shows the ADSL line information.
Item
Port selection menu
Operation state
Current status
Operation mode
Actual standard
Attain rate (bps)
Attenuation (1/10 db)
Current SNR (1/10 db)
Output power (1/10 dbm)
Rate (bps)
Interleave delay (ms)
Block length (byte)
NCT480 IP DSLAM User Guide
50
Figure 3-1 DSL Status Dialog
Description
Select the ADSL port interface to be display with relative parameters.
Operational state of the DSL port.
Indicates current state of the DSL line. This is a bit-map of possible conditions.
Operation mode used by the DSL port.
Actual standard used for connection, based on the outcome of the negotiation with the
ATU-R
Indicates the maximum currently attainable data rate by the ATU-x. This value will be
equal to, or greater than the current line rate.
Measured difference in the total power transmitted by the peer ATU-x and the total
power received by this ATU-x.
Noise Margin as seen by this ATU-x with respect to its received signal in tenth dB.
Measured total output power transmitted by this ATU-x. This is the measurement that
was reported during the last activation sequence.
Actual transmit rate on this channel.
Interleave delay for this channel.
Indicates the length of the channel data-block, on which the CRC operates.
Table 3-1 DSL Status Dialog Description
YML856 Rev3
www.netcomm.com.au