Attach The Earth Ground - NetComm IP DSLAM NCT480 User Manual

Attach the earth Ground

Complete the instruction to connect the grounding cord of NCT480.
1 ensure the power switch is set to the off position.
2 Use the Philip-head screwdriver to turn the screws on the earth ground screw point.
3 Strip one end of the ground wire to the ground hole of system
4 Connect the other end of the ground wire to a suitable grounding point at your site.
The equipment has provision for a permanently connected Protective Earthing Conductor.
YML856 Rev3
www.netcomm.com.au
Figure 4-8 Earth Ground of NCT480
NCT480 IP DSLAM User Guide NCT480 IP DSLAM User Guide