NetComm IP DSLAM NCT480 User Manual page 25

Connecting a Console
Complete the following steps to connect the NCT480 Console management.
1 Connect the RJ-45 to DB-9 adapter cable to the Console port on the NCT480.
2 Connect the other end (female) to the computer's COM port.
Configure the PC's COM port
Use your terminal emulation program (such as HyperTerminal in Windows) to set your COM protocol to the
following settings:
Parameter
Baud rate
Data bits
Parity
Start bits
Stop bits
flow control
YML856 Rev3
www.netcomm.com.au
Figure 4- RJ-45 to DB--female Adapter cable for Console Management
Figure 4-3 NCT480 Console Port Management Cabling
Setting
9600
8
None
1
1
None
Table 4- NCT480 Console Management Setting
NCT480 IP DSLAM User Guide NCT480 IP DSLAM User Guide
5