Layer Information - NetComm IP DSLAM NCT480 User Manual

Layer Information

The Layer Information will display ATM and Channel layer information.
Item
Port selection menu
Tx cell
Rx cell
Idle cell
Total cell
User cell
Attain rate (bps)
Interleave delay (ms)
Block length (byte)
Time elapse (sec)
Received Blocks
Transmitted Blocks
Corrected Blocks
Uncorrected Blocks
No cell delineation count
Out of cell delineation count
header error check count
YML856 Rev3
www.netcomm.com.au
Figure 3- Layer Information Dialog
Description
Select the ADSL port interface to be display with relative parameters.
Provides Tx ATM cell counter.
Provides Rx ATM cell counter.
Number of idle cells.
Number of total cell
Number of user cell
Indicates the maximum currently attainable data rate by the ATU-x. This value will be
equal to, or greater than the current line rate.
Interleave delay for this channel.
Indicates the length of the channel data-block, on which the CRC operates.
Total time elapsed in seconds.
Count of all encoded blocks received on this channel since agent was reset.
Count of all encoded blocks transmitted on this channel since agent was reset.
Count of all encoded blocks received with corrected error on this channel since agent reset.
Count of all encoded blocks received with uncorrected error on this channel since
agent was reset.
Number of packets with NCD (No Cell Delineation) error.
Number of packets with OCD (Out of Cell Delineation) error.
Number of packets with HEC (Header Error Check) error.
Table 3- Layer Information Dialog Description
NCT480 IP DSLAM User Guide NCT480 IP DSLAM User Guide
51