Programming - Changing Hot Water Mode To Ambient - WaterLogic WL350 Operating, Installation And Service Manual

PROGRAMMING INSTRUCTIONS
CHANGING HOT WATER MODE TO AMBIENT WATER
WL350 Water Treatment Systems comes with set to Hot / Cold, which can be changed to
Ambient / Cold settings. On the
Pins 2 and 3.
Unplug Power Cord and remove Top Cover to access Energy Saver PCB.
Energy Saver PCB – P/N EN-6131 – WLCP PN 20-0075
WL350 Water Treatment Systems comes with Hot and
Cold Water factory settings.
PCB Jumper JP9 in positions - Pin 1 and 2
Change to Ambient and Cold by moving PCB Jumper
JP9 to positions – Pin 2 and 3
WL350 Operating, Installation, and Service Manual
Move the Jumper on JP9 from Pins 1 and 2 to
Energy Saver PCB,
Pin Numbers
1 2
1 2
2 3
Page 23 – Revision 8-30-2016
3