Example Of Incorrect Resonator Connection - NEC PD754144 User Manual

CHAPTER 6 PERIPHERAL HARDWARE FUNCTION
The X2 pin of the µ PD754244 is internally pulled up to V
Cautions 1.
in the STOP mode.
2. Wire the portion enclosed by the dotted lines in Figures 6-16 and 6-17 as follows to
prevent adverse influence by wiring capacitance when using the system clock oscil-
lator.
• Keep the wiring length as short as possible.
• Do not cross the wiring with any other signal lines.
• Do not route the wiring in the vicinity of a line through which a high alternating
current is flowing.
• Always make the potential at the connecting point of the capacitor of the oscillator
the same level as V
Do not connect the wiring to a ground pattern through which a high current is
flowing.
• Do not fetch signals from the oscillator.
Figure 6-18 shows incorrect examples of connecting the resonator.
Figure 6-18. Example of Incorrect Resonator Connection (1/3)
(a) Wiring length too long
µ
• PD754144
µ PD754144
CL1
.
SS
CL2 V
SS
User's Manual U10676EJ3V0UM
by a resistor of 50 kΩ (typ.)
DD
µ
• PD754244
µ PD754244
X1 X2 V
SS
109