Riso V8000 Series Technical Manual page 320

No.
550 Variable Main Motor Speed
Use the speed keys to rotate the main motor.
551 Print Drum On Position T
== Spare (function not available) ==
552 Print Drum On Position B
Stops the print drum at position B.
553 Print Drum Drive Release Action
Performs the drive release action using the left/right pulse motors.
554 Print Drum Drive Connection Action
Performs the drive connection action using the left/right pulse motors.
555 Print Drum Locking Action
Locks the print drum.
556 Print Drum Release Action
Unlocks the print drum.
557 Inking Action
Perform the following operations in sequence.
Make confidential master beforehand.
Rotate the main motor (30 rpm) and apply ink.
Lower the inside press on the print drum after the ink sensor goes ON.
Rotate the main motor at 60 rpm.
The main motor stops after 100 rotations at position T
* Both the ink sensor and overflow sensor are enabled.
* The inking time is set during replacement.
558 Print Drum Ink Drainage
Prints 250 sheets or until the STOP key is pressed at fixed printing speed of 5 and
printing density of 3.
No inking action and deactivation of ink sensor.
Make sure to make master by test mode No.50 before activating test mode No.558
559 Master Top Clamp Positioning (Master top position A)
Performs front position A positioning (With Master Top Position A Adjustment).
560 Master End Clamp Positioning (Master end position A)
Performs rear position A positioning (With Master End Position A Adjustment).
561 Clamp Home Action
Moves the clamp front/rear units to the home position.
562 Master Top Clamp Opening/Closing Action
Moves clamp unit front → Opens clamp → Resets clamp HP → Moves clamp unit
front → Closes clamp to master loading sensor → Closes clamp → Resets clamp
HP
563 Master end Clamp Opening/Closing Action
Moves clamp unit front → Opens clamp → Resets clamp HP → Moves clamp unit
front → Closes clamp to open/close HP sensor → Closes clamp → Resets clamp
HP
564 Inner Pressure Clutch ON/OFF
Switches the inner pressure clutch ON for 1 second and then OFF again.
567 Standby Positioning
Stops at the paper drum standby position (150° from position T)
Sensors, switches
[17 - 21]
CHAPTER 17. TEST MODE
PRINT DRUM TEST MODE
1/2 Switch
O
O
O
O
O
O
O
O
O
O
O
O
O