Removing The Vertical Transport Roller G And Master Disposal Belt (1St Master Disposal Unit) - Riso V8000 Series Technical Manual

CHAPTER 11. MASTER DISPOSAL SECTION
10. Removing the Vertical Transport Roller G and Master Disposal Belt
(1st Master Disposal Unit)
(1) Remove the vertical transport roller holder.
(2) Remove the master disposal jam sensor ass'y.
(3) Remove the disposal plate motor.
(4) Detach the E-ring and bearing on one side of the guiding roller, slide out the roller, and remove.
(5) Loosen the set screw on gear Z24 and remove from vertical transport roller G.
* The gear on the "Gear Z24" should face inside and the boss with the set screw faces outside.
(6) Pull out and remove vertical transport roller G from the keyhole shaped hole in the frame plate.
(7) Remove the master disposal belt from vertical transport roller G.
Vertical transport roller G
Gear Z24
[11 - 10]
Refer to page 11-19 for removing these
parts from the 2nd Master Disposal Unit.
Guiding roller
Master disposal belt
P1119
Guide roller
P1120