Removing The Af Read Pulse Motor - Riso V8000 Series Technical Manual

5.

Removing the AF Read Pulse Motor

(1) Loosen the three screws (M4 x 6) at the front of the AF cover, remove the two screws (M4 x 10) from
underneath, and then remove the AF cover.
(2) Remove one screw (M4 x 6) from the wire harness bracket ass'y and set the bracket ass'y aside.
(3) Remove the open lever with the open lever spring attached.
(4) Remove the tension spring, and by removing two screws (M3 x 6) detach AF read pulse motor from
the AF unit, together with the motor tension bracket.
Wire harness bracket ass'y
AF read pulse motor
AF read pulse motor
P1317
Tension spring
[13 - 11]
CHAPTER 13. AF SCANNING SECTION
Open lever
Open lever spring
Motor tension bracket
P1318
P1319