Riso V8000 Series Technical Manual page 236

CHAPTER 13. AF SCANNING SECTION
Original ejection roller
(13) Remove plastic lock ring from rear of the original ejection roller shaft, and then remove the timing
pulley together with parallel pin.
(14) Remove E-ring and detach the metal bushing.
(15) Remove plastic lock ring from front of the original ejection roller shaft and detach the metal bushing.
(16) Detach the original ejection roller shaft.
< REAR >
< REAR >
Plastic lock ring
Timing pulley
Timing pulley
Original ejection roller
Plastic lock ring
P1334
Original ejection roller
Parallel pin Metal bushing
E-ring
Plastic lock ring
[13 - 18]
Original ejection roller
P1335
< FRONT >
< FRONT >
Plastic lock ring
Metal bushing
P1336