Removing The Drive Transmit Release Sensor, Horizontal Centering Hp Sensor, And Position A Sensor (No.2) - Riso V8000 Series Technical Manual

CHAPTER 8. PRINT DRUM SECTION
16. Removing the Drive Transmit Release Sensor, Horizontal
Centering HP Sensor, and Position A Sensor (No.2)
(1) Remove following parts from the print drum.
· Print drum cover
· Side frames L and R
(2) Slide print drum front frame ass'y towards the front until the surface of the MF holder and support
shaft becomes flat with each other.
Removing the Drive transmit release sensor and Horizontal centering HP sensor
(3) Unplug the connectors and remove the two sensors.
Removing the Position A sensor (No.2)
(3) Remove the mounting screw (M4x8) and unplug connector. Remove the sensor attached on the
mounting plate.
MF holder
The surface of the MF holder and
Support shaft should be about flat
with each other.
Drive transmit release sensor
Support shaft
P08085
Position A sensor mounting bracket F
Print drum front frame ass'y
Position A sensor (No.2)
P08087
Horizontal centering HP sensor
[8 - 36]
P08086